Astm D 3828 – 02 pdf free download

Standard Test Methods for
Flash Point by Small Scale Closed Cup Tester1

This standard is issued under the fixed designation D 3828; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of the last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (e) indicates an editorial change since the last revision or reapproval.

This standard has been approved for use by agencies of the Department of Defense.

1. Scope *

1.1 These test methods cover procedures for a smdeterminationed tester’s determination of the flash point. The
procedures may be used to determine the actual flash point
the temperature of a sample or whether a product will or will not
flash at a specified temperature (flash/no flash).

1.2 This standard should be used to measure and describe
the properties of materials, products, or assemblies in response
to heat and flame under controlled laboratory conditions and
should not be used to describe or appraise the fire hazard or
fire risk of materials, products, or assemblies under actual fire
conditions. However, the results of this test may be used as
elements of a fire risk assessment that takes into account all
of the factors which are pertinent to an assessment of the fire
hazard of particular end use.

1.3 The values stated in SI units are to be regarded as
standard. The values in parentheses are for information only.

1.4 This standard does not purport to address all of the
safety concerns associated with its use if any. It is the
responsibility of the user of this standard to establish appropriate safety and health practices and determine the application

Click below to download Astm D 3828 – 02 pdf free

Click here to download Astm D 3827 – 92 (Reapproved 2002) Pdf Free Download

Leave a Comment